O.S. Engines GGT 15

2-tahtinen hehkutulppa bensamoottori polttoaine pumpulla.

Sopii hyvin .60-.91 kokoluokan lennokkeihin

Käyttöohjeen löydät tästä

Video 1

OS GGT15 2-tahti hehku-bensa moottori

Tuotenumero: OS3A200
440,00 €Hinta
  • INCLUDES

    GGT15 Engine wE4040 Muffler, G5 Glow Plug and Instructions

     

     

    REQUIREMENTS

    Fuel: Gasoline and 2-cycle oil in a 50:1 mixture
    Propeller depending on aircraft: Sport,13x8-11
    Acro, 14x8-10
    Scale, 15x6-8
    Glow starter & field equipment

     

     

    SPECIFICATIONS

    Displacement: 0.912 cu in (14.95cc)
    Bore: 1.091 (27.7mm)
    Stroke: 0.976 (24.8mm)
    Practical RPM Range: 2,000-11,000
    Output: 2.35 ps2.32 hp 15,000 RPM
    Weight: Engine, 21.5oz (610g)
    Muffler, 6.28oz (178g)
    Distance between Mounting Hole Centers Same Side: 0.98 (25mm)
    Distance between Mounting Hole Centers Opposite Side: 2.04 (52mm)
    Width at Mounting Tabs: (61mm)
    Width of Crankcase below Mounting Tabs: 1.7 (44mm)
    Width from Crankcase Center to Exhaust Outlet: 4.4 (112.3mm)
    Heightbottom of Mounting Tabs to Muffler Bottom: 1.5 (37.6mm)
    LengthCrankcase Center to Drive Washer: 2.6 (66.8mm)
    LengthCrankcase Center to end of Crankshaft: 4.03 (102.6mm)
    Length from Pump to end of Crankshaft: 5.6 (142mm)
    Crankshaft Size: UNF 516-24
    Rearward Needle Valve Angle Relative to Engine: 30
    Needle Valve Adjustment
    Gradually open throttle fully when engine is started.
    Close needle valve 30-45 increasing RPM
    When RPM starts decreasing, close needle valve 60-90, then open
    slowly 15 per second as RPM increases
    Open needle valve 90 further from point where max RPM is obtained
    Fly model until running in is completed (10 tanks of fuel)
    After running in is completed, set idle around 3000RPM
    Stop engine, close mixture control valve 15, note idling RPM
    90 opened position from where max idling RPM is obtained is
    optimum mixture control valve position
    Mixture Control Valve Position
    Never try to adjust until needle valve adjustment is performed
    Open mixture control valve one turn (360), open & close a few
    times to be sure there is no resistance during throttle movement
    Close mixture control valve 30
    Rotate throttle until resistance is felt when opening throttle
    from closed position
    Open mixture control valve approximately 90 from this point-this
    is the initial mixture control valve position

Uusi Porvoontie 1434

01190 Box

Finland

Y-tunnus 1772904-1

  • Facebook Social Icon
  • YouTube

©2019 by Sky dream hobby. Proudly created with Wix.com